A more effective way of increasing efficiency of Carnot engine where TH is source and TL is the sink is:

Increasing efficiency is impossible

Increase TH, keeping TL as constant

Decrease TL, keeping TH constant

A more effective way of increasing efficiency of Carnot engine where T

1.	A more effective way of increasing efficiency of Carnot engine where TH is source and TL is the sink is:
A.	Increase TH, keeping TL as constant
B.	Decrease TL, keeping TH constant
C.	Increasing efficiency is impossible
D.	None of the above
Answer» C. Increasing efficiency is impossible

Discussion

No Comment Found

Related MCQs

A car engine operates with a thermal efficiency of 35%. Assume the air-conditioner has a coefficient of performance of 3 working as a refrigerator cooling the inside using engine shaft work to drive it. How much fuel energy should be spend extra to remove 1 kJ from the inside?
In a cryogenic experiment you need to keep a container at -125°C although it gains 100 W due to heat transfer. What is the smallest motor you would need for a heat pump absorbing heat from the container and rejecting heat to the room at 20°C?
A cyclic machine, as shown below, receives 325 kJ from a 1000 K energy reservoir. It rejects 125 kJ to a 400 K energy reservoir and the cycle produces 200kJ of work as output. Is this cycle reversible, irreversible, or impossible?
An air-conditioner provides 1 kg/s of air at 15°C cooled from outside atmospheric air at 35°C. Estimate the amount of power needed to operate the air-conditioner.
A heat pump is used to meet the heating requirements of a house and maintain it at 20°C. On a day when the outdoor air temperature drops to 2°C, the house is estimated to lose heat at a rate of 80,000 kJ/h. If the heat pump under these conditions has a COP of 2.5, determine the rate at which heat is absorbed from the cold outdoor air.
A heat pump is used to meet the heating requirements of a house and maintain it at 20°C. On a day when the outdoor air temperature drops to 2°C, the house is estimated to lose heat at a rate of 80,000 kJ/h. If the heat pump under these conditions has a COP of 2.5, determine the power consumed by the heat pump.
The food compartment of a refrigerator is maintained at 4°C by removing heat from it at a rate of 360 kJ/min. If the required power input to the refrigerator is 2kW, determine the rate of heat rejection to the room that houses the refrigerator.
The food compartment of a refrigerator is maintained at 4°C by removing heat from it at a rate of 360 kJ/min. If the required power input to the refrigerator is 2kW, determine the coefficient of performance of the refrigerator.
A car engine with a power output of 50 kW has a thermal efficiency of 24 percent. Determine the fuel consumption rate of this car if the fuel has a heating value of 44,000 kJ/kg .
Heat is transferred to a heat engine from a furnace at a rate of 80 MW. If the rate of waste heat rejection to a nearby river is 50 MW, determine the thermal efficiency for this heat engine.

A more effective way of increasing efficiency of Carnot engine where TH is source and TL is the sink is:

Discussion

No Comment Found

Related MCQs

Reply to Comment