A hydraulic press has a ram of 15 cm diameter and plunger of 1.5 cm. i – McqOptions

MCQOPTIONS

1.	A hydraulic press has a ram of 15 cm diameter and plunger of 1.5 cm. it is required to lift a mass of 1000 kg. The force required on plunger is nearly equal to
A.	100 N
B.	1000 N
C.	10,000 N
D.	10 N
Answer» B. 1000 N

Discussion

No Comment Found

Related MCQs

In turbulent flow
\(Q = \frac{{\partial u'}}{{\partial x}} = - \frac{{\partial v'}}{{\partial y}}\) for a turbulent flow signifies
Consider the turbulent flow of a fluid through a circular pipe of diameter, D. identify the correct pair of statements.I. The fluid is well-mixedII. The fluid is unmixedIII. ReD < 2300iv. ReD > 2300
In turbulent flows through rough pipes, the ration of the maximum velocity to the mean velocity is
‘‘Eddy viscosity’’ means that it is
Over a flat plate, thickness of turbulent boundary layer at a distance x from leading edge is _____.
In a fully developed turbulent flow through a circular pipe, a head loss of h1 is observed. The diameter of the pipe is increased by 10% for the same flow rate and a head loss of h2 is noted. Assume friction factor for both the cases of pipe flow is the same. The ratio of \(\frac{h_2}{h_1}\) is closest to
In the moody diagram is shown in the figure below, the friction factor for turbulent flow in the smooth pipe is given by the curve
In smooth pipes, if R represents Reynold's number, Friction factor for turbulent flow is given by:
During the opening of a valve in pipeline, the flow is