A binary-weighted digital-to-analog converter has an input resistor of – McqOptions

MCQOPTIONS

1.	A binary-weighted digital-to-analog converter has an input resistor of 100 k. If the resistor is connected to a 5 V source, the current through the resistor is:
A.	50 A
B.	5 mA
C.	500 A
D.	50 mA
Answer» B. 5 mA

Discussion

No Comment Found

Related MCQs

A binary-weighted digital-to-analog converter has a feedback resistor, R, of 12 k. If 50 A of current is through the resistor, the voltage out of the circuit is:
The resolution of a 0–5 V 6-bit digital-to-analog converter (DAC) is:
An 8-bit digital-to-analog converter (DAC) has a resolution of 0.125 V.
A binary-weighted resistor used in a digital-to-analog converter (DAC) is only practical up to a resolution of ________.
The key advantage of the successive approximation analog-to-digital converter (ADC) is its conversion speed.
One way to determine the resolution of a digital-to-analog converter (DAC) is to compare the ratio of one step voltage to the maximum output voltage.
Inaccurate analog-to-digital conversion may be due to ____________.
In a binary-weighted digital-to-analog converter (DAC), the values of the input resistors are chosen to be proportional to the binary weights of the corresponding input bits.
Which is not an analog-to-digital (ADC) conversion error?
A binary-weighted digital-to-analog converter has a feedback resistor, Rf, of 12 k. If 50 A of current is through the resistor, the voltage out of the circuit is: