A and B are at the same elevation of 2.5 m above datum in the valve an – McqOptions

MCQOPTIONS

1.	A and B are at the same elevation of 2.5 m above datum in the valve and pipe line as shown in the given figure. The velocity head of 0.5 m, head loss in the valve of 0.2 m and pressure head of 2.5 m are the parameters at A. The piezometric head at B is equal to:
A.	5.0 m
B.	5.5 m
C.	5.3 m
D.	4.8 m
Answer» E.

Discussion

No Comment Found

Related MCQs

Friction factor of pipes depends on
A Newtonian fluid having a viscosity of 0.39 Ns/m2 and specific gravity of 0.91 flows through a 25 mm diameter pipe with velocity of 3.6 m/s. Then the value of Reynold’s number is:
For maximum power transmission through a pipe line, the frictional head loss equals
A pipeline AB of diameter 30 cm and of length 400 m carry water at the rate of 50 litres/sec. The flow takes place from A and B where point B is 30 meters above A. Pressure at B is 2 ksc. Pressure at A is (Take f = 0.008)
For laminar flow in pipes, the momentum correction factor is :
In case of transmission of hydraulic power by a pipeline to a turbine in a hydroelectric power station, the maximum power transmission efficiency through the pipeline is
An orifice meter is used to measure the:
_____ is the point in a fluid stream where the diameter of the stream is the least, and fluid velocity is maximum.
Energy grade line(EGL) represents the
Air flows through a duct, and the Pitot-static tube measuring the velocity is attached to a differential manometer containing water. If the deflection of the manometer is 100 mm, assuming the density of air is constant and equals to 1.22 kg/m3, and that the coefficient of the tube is 0.98. The air velocity will be.