6.0 kJ of conduction heat transfer has to take place in 10 minutes from one end to other end of a metallic cylinder of 10 cm cross-sectional area, length 1 metre and thermal conductivity as 100 W/m.K. What is the temperature difference between the two ends of the cylindrical bar?

6.0 kJ of conduction heat transfer has to take place in 10 minutes fro

1.	6.0 kJ of conduction heat transfer has to take place in 10 minutes from one end to other end of a metallic cylinder of 10 cm cross-sectional area, length 1 metre and thermal conductivity as 100 W/m.K. What is the temperature difference between the two ends of the cylindrical bar?
A.	\[80{}^\circ C\]
B.	\[100{}^\circ C\]
C.	Viscosity, speed and load
D.	\[160{}^\circ C\]
Answer» C. Viscosity, speed and load

Discussion

No Comment Found

Related MCQs

Which one of the following types of bearings is employed in shafts of gearboxes of automobiles?
In a single row deep groove ball-bearing, cages are needed to:
A certain minimum number of teeth is to be kept for a gear wheel:
Which of the following stresses are associated with the design of pins in hushed pin-type, flexible coupling? 1. Bearing stress 2. Bending stress 3. Axial tensile stress 4. Transverse shear stress Select the correct answer using the codes given below:
Match List-I with List-II and select the correct answer using the codes given below the lists: List-I List-II A. Single-plate friction clutch 1. Scooters clutch B. Multi-plate friction clutch 2. Rolling mills C. Centrifugal clutch 3. Trucks D. Jaw clutch 4. Mopeds Codes:
For a two-dimensional state \[({{\sigma }_{1}},\,{{\sigma }_{2}},\,{{\sigma }_{1}}\]>\[0,\,{{\sigma }_{2}}\]
Match List-I (Machine element) with List-II (Cause of failure) and select the correct answer using the codes given below the lists: List-I List-II A. Axle 1. Shear stress B. Cotter 2. Tensile/Compressive stress C. Connecting rod 3. Wear D. Journal bearing 4 Bending stress Codes:
The shearing area of a key of length 'L' breadth 'b' depth 'h' is equal to:
Which of the following stresses are associated with the tightening of nut on a bolt? (1) Tensile stress due to the stretching of bolt (2) Bending stress due to the bending of bolt (3) Crushing and shear stresses in threads (4) Torsional shear stress due to frictional resistance between the nut and the bolt. Select the correct answer using the codes given below:
Which one of the following statements with regard to belt drives is not correct?

6.0 kJ of conduction heat transfer has to take place in 10 minutes from one end to other end of a metallic cylinder of 10 cm cross-sectional area, length 1 metre and thermal conductivity as 100 W/m.K. What is the temperature difference between the two ends of the cylindrical bar?

Discussion

No Comment Found

Related MCQs

Reply to Comment