1 Mbps BPSK receiver detects waveform S1(t) =Acosω0t or s2(t) = -Acos – McqOptions

MCQOPTIONS

1.	1 Mbps BPSK receiver detects waveform S1(t) =Acosω0t or s2(t) = -Acosω0t with a matched filter. If A= 1 mV, then the average bit error probability assuming single-sided noise power expected density N0 = 10-11 w/hz is nearly
A.	Q (0.63)
B.	Q (0.16)
C.	\(Q\sqrt {0.1} \)
D.	\(Q\sqrt {0.3} \)
Answer» D. \(Q\sqrt {0.3} \)

Discussion

No Comment Found

Related MCQs

Half power bandwidth is also called ______
_______ is equal to width of main spectral lobe.
In digital communication system, in order to increase noise immunity, it is necessary to increase _________
The performance of modulation scheme is not measured in terms of __________
A desirable modulation scheme provides _________ bit error rates at __________ received signal to noise ratios.
Modern mobile communication systems use analog modulation techniques.
For a 10 bit PCM system the signal to quantization noise ratio is 62 dB. If the number of bits is increased by 2, then the signal to quantization noise ratio will
A 70 MHz carrier is QPSK modulated by a 1.544 Mbps T1 data stream. The transmitter employs a raised-cosine filter with α = 0.2. What is the transmitted bandwidth of the signal?
A 12-bit ADC has input signal range of ± 1 V. The signal to quantization noise ratio if a sine wave signal with 0.25 V peak voltage is given as input is:
In which modulation does the signal convert its analog information into a binary sequence, i.e., in 1s and 0s